tube joint

thingiverse

This resin printed single axis joint uses a high quantity of resin and could further be optimized to save resin. The sleeved end slips on to a 2.5 inch OD aluminum tube. There is a central support which can be removed by rocking and twisting. Supports from the base to the inner and outer sleeve tubes are a must. there is a through hole in each of the halves to allow wire running through there are two versions of the joint. Each has a different range of motion The diameter of the pivot hole 19mm.. if remember right, I will check and update I chose to machine brass bushings to press in and add a central pivot point as to not wear the print.