TurboGrafx-16 Jewel Case Insert

thingiverse

TurboGrafx-16 Jewel Case Hue Card Insert Store your TurboGrafx games like they were intended in jewel cases! Don't like how much plastic the full part will take, well it is your lucky day, I made a lite version that uses roughly 25% less plastic and averaged 20% faster print times then the full version. Even better store two games in the same case for only about 50% of the plastic as one full insert! This is designed to fit a standard jewel case, and a standard hue card. Not guaranteed to fit all jewel cases, or hue cards. This print also requires reasonably tight printing tolerances for the retaining nubs to function properly. For these reasons, I have included a test print and I recommend using it. The test print is only 25-30% of the material compared to a full version, and will allow you to make sure the insert will fit your jewel case properly. A maximum .1mm Layer height is recommended due to the size of the retaining nubs. Requires Supports Brim is recommended but not required. Updates- 10-18-2018 Added an insert that holds two Hue Cards and edited description to match.