TURN TABLE - 3D SCANNER / PHOTOGRAMMETRY - HEAVY DUTY

thingiverse

TURN TABLE - 3D SCANNER / PHOTOGRAMMETRY - HEAVY DUTY If you print this project, and you are happy with the final part, do not forget to buy me a roll of filament, or at least few meters - in order for me to be able continue to test and improve these projects or to design new ones! If you are not happy with this design or you have problem with your printed parts - send me a message, we will try to fix it together! :) If you do not want or you can't afford to buy me a roll of filament ... its ok, I still hope you enjoy printing my designs! Pace! Design for Heavy Duty Projects 300X300 PRINT TABLE For EXTREME LOADS - or a PERMANENT STATIONARY SETUP - a photo/scanning station - remove legs and use the unit on a flat surface, of course with a hole for the motor and and one for central bolt! Secure it with M4 Countersunk bolts - using the Leg Holes. Gear 10/1 ratio; gears are offset with 0.2mm one from another to compensate for print glitches. Design to use a Stepper Motor - Nema 17 - use any of the projects already online - to operate and control the turn table and the camera shutter / scanner. Motor Gear use a M4 Stud Bolt 6-8mm and a M4 Nut - Are added different gears, with bore from 5.1 to 5.8mm. Base on your printer capabilities, use the one you see fit! In my case I start printing from 5.1mm - what was impossible to fit to the motor and end with 5.6mm what was a tight fit, however... I think is ok. Nema Motor use 4 X M3 8mm countersunk bolts Legs 6 X M4 18 -20mm counter sunk bolts + nuts + washers Air Soft Balls 6.0mm - metal; clean all bearing channels to ensure a smooth movement. All parts are check for naked edges or errors - therefore ... all are going to be printable! If the design is good or if the parts are going to fit... that's another story! Design to print without support ... mostly... except for the parts what need support :) By Costa