Turntable for 3D scanning

thingiverse

Turntable for 3D scanner. What will be needed: 4x screws M6x 20mm 4x screw M3x 15mm 1x 220V clutch 1x cable with 220V socket 4x locking washer ´ You bought 1x stepper motor 0.8-1 revolutions per minute, it on Amazon https://www.amazon.co.uk/dp/B07FTGD51D?psc=1&smid=AT1Q9BWPH6Y68&ref_=chk_typ_imgToDp It took me 16 hours to print all the parts Assemble everything according to the photo. It's nothing difficult. You will need: M6 and M3 taps and a drill with a diameter of 6 and 7 mm Procedure: print all the parts, put on the rolls, it will be necessary to drill the inner holes with a 6 mm drill and make an M6 thread from both sides in the lower part where the rolls will be put on, put the tool for centering the motor on the motor, center it so that the motor is in the ideal center. Drill 3 mm hole holes in the motor through the ring to the bottom of the lower part Make an M3 thread in the motor ring from both sides. Screw everything tightly drill a hole for the cable in the lower part. Then just plug in the engine. Více o zdrojovém textuPro další informace o překladu je potřeba zdrojový text Odeslat zpětnou vazbu Postranní panely