Turtle Dreams

myminifactory

Turtle Dreams, faux stained glass. Scaled to be printed on an 8 x 8 build area.  Printed at .3mm in ABS.  Frame sliced at 2 perimeters, two tops, two bottoms, 15 percent rectiliner infill.  The "glass" pieces require a seperate slice profile, as follows: 2 perimeters, 2 bottoms, 0 tops, 10 to 20 percent honeycomb infill.  "Glass" pieces print upside down, and are to be flipped over after printing, and glued into the recesses in the upright frame.  Note: if you don't create a new slicer profile, the glass might be too thick to permit enough light to show through, hence the glass profile, which has only two layers for light to show through, even though it prints to 9 layers.  Done this way to allow easier glueing into the frame, and to help prevent light leaks.  Use some white glue or plastic cement to glue model together. My first submission to My Mini Factory, and its is exclusive to your site.  Hope you enjoy!