TUSM Tripod Extension Arm

thingiverse

This is an adaption of my design "The Ultimate Smartphone Mount" to create an extension arm for flat lay photography. In addition to the files provided, you'll need to model the hotshoe that suits your tripod and get a few non-printed components too. <iframe width="560" height="315" src="https://www.youtube.com/embed/XyZpiN5B8Zg" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe> ### Files ### 1. MNT: Attaches to your tripod. The .step file has been provided so you can model the hot shoe for your tripod. 2. GRIPPER: The Ultimate Smartphone Mount adapted to fit the square tube to hold your phone securely in place. 3. HOOK: Cap component for other end with integrated hook for counter weight. 4. SCREW: For securing the tube in the desired position. 5. CW: Counter Weight vessel that can be filled with water and attached to the hook if needed. ### Components # You will need these additional components to complete the assembly: 1. Elastic band x 1 2. 19mm x 19mm square tube x 1 (I would not recommend more than 1m in length) 3. 2 x 6mm OD x 35mm long bolts and corresponding nuts 10mm flat-to-flat ### Recommended Print Settings ### • PLA, ABS etc • 0.2mm layer height • Min. 1.2mm shell • 40% infill • Support overhang angle > 70° - support is only required where the hook and gripper attached to the square tube ### Don't forget to share your hot shoe modifications! ### #Get original Ultimate Smart Phone mount ↓# https://www.thingiverse.com/thing:4297510 <iframe width="560" height="315" src="https://www.youtube.com/embed/5xxuFSXgIpc" frameborder="0" allow="accelerometer; autoplay; clipboard-write; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>