TV Remote Holder - Arm Chair

prusaprinters

<p>You can place the TV Remote Control adjacent to your armchair at a convenient height.</p><p>The chain goes over the arm. &nbsp;There are 1 mm tall teeth on one side of each link that secures the chain to the fabric arm. &nbsp;I was surprised at its holding power. &nbsp;If the arm is non-fabric, there are no teeth on the other side of each link. &nbsp;the chan can then be fastened to the plate, which is placed under the seat cushion. &nbsp;I used four chains altogether in the fabric chair shown in the photos.</p><p>One of the three prints provides two five-link chains. &nbsp;You will likely need to print these a couple of times to get the chains of sufficient length. &nbsp;</p><p>The chain tabs are sufficiently flexible to allow for combining.</p>