TV support for camcorder

thingiverse

When I want to see my footage on my TV, I had never found a secure and practical place for my camcorder. So I made this mast that permit to fix it with its video and power cables. Note that for decoration propose I add a grip from MaxGlide. The untested M8-M4 adaptor is here because I made the same work on an other adaptor after I break a version that was similar to the one I use on the picture (by screwing it with the internal nut in a bad position). I think it's stupid not to propose this enhancement that can make a stronger fixation with 4 nuts (not useful here) or hiding the 2 nuts. Also note that you can adjust the threaded rod level through the upper end to avoid the upper screw to fall down. Needed parts (see picture): Threaded Rod M8: 1 Nut M8: 8 Big washer M8: 4 Screw "photo format" (1/4 inch large × 1/2 inch length): 1 Screw M4 large head 10mm: 2 Screw M3 cylindrical head 20mm: 4 Nut M3: 4 Print Settings Rafts: Doesn't Matter Supports: Doesn't Matter Notes: I print it at 105% scale because my printer make holes a bit small (I was obliged to drill the 3mm holes to finish it). Post-Printing I was obliged to drill the 3mm holes to finish it... It's possible you'll need too !