u360gts Tracker mini case

thingiverse

I created this mini case as an alternative to the original U360GTS tracker case. The u360gts project can be found here: https://github.com/raul-ortega/u360gts I also created multiple PCB to make wiring easy and to have a place to mount the IO ports to. All the parts I used are listed in the Materials_used.xls file. Additional case control board: https://github.com/skaman82/u360gts-ctrl Build notes: https://github.com/skaman82/u360gts-ctrl/blob/master/build_notes_u360.md UPDATE NOTES 20.01.2020: • Updated the tripod mount • Updated Module PCB gerber file 22.01.2020: • Updated the Box2.stl > hole and mount for a 3mm IR receiver • Updated the Lid_Box1.stl > hole and mount for a 3mm IR LED and vent holes 27.01.2020: • Updated Box1.stl to match the new POWER-PCB • Updated POWER-PCB Gerber file • Updated the Box2.stl > bit tighter screw holes for servo mounting 28.01.2020: • Updated the Lid_Box1.stl and Lid_Box2.stl > slightly bigger sink holes for the screws • Updated the Gears.stl > slightly larger to remove play completely 02.02.2020: • Updated the Box1.stll > vent holes • Updated Gears.stl > better fit 07.02.2020: New extended controls PCB allowing manually pan the tracker to get to the screws of the base. Also: Automatic parking, SmartAudio relay VTX control, VTX power switch, voltage monitoring. Project files: https://github.com/skaman82/u360gts-ctrl 08.02.2020: Added the Backplate in two versions 11.02.2020: Updated Box1.stl > raised FC a bit for better USB access, remover one FC post and fixed FC hole distance. Also slightly larger vent hole on the side. 14.02.2020: Fixed OLED PCB gerber file (VUSB was powering the whole Tracker before) 16.02.2020: Fixed Backplate 17.02.2020 Uploaded the final PCB files and material list 09.05.2020 Corrected wrong diode orientation on the OLED PCB 19.05.2020 Added new slipping adapters to support more slipping models (see Slip-Ring-Select.jpg) 26.05.2020 Added more optional files like RX Module Covers, additional tripod stand and an alternative arm for the LZR antenna (thanks Mike) 09.06.2020 Added optional 10K I2C pull-ups on the RX PCB 09.07.2020 New stls > Changed the top box and lid, new mag stands to get rid of interference. Updated material list. 27.07.2020 New smaller PCB for the arm to move the FS module further away from the mag. New arm stl will be available shortly after some testing. 19.09.2020 Uploaded a new arm design for the new RX PCB (needs an JST ZH 4pin connector)