UDOO-X86 Case

thingiverse

I designed it using OpenJSCAD. JSCAD file is also shared. Following parameters can be adjusted in JSCAD for your need (if you are increasing top height to accommodate CPU FAN, then base height (BH) needs to be adjusted). In base jscad, adjust these parameters var BH=15; //base height. 15 for no SSD, 25 for with SATA SSD. 20 for only SATA SSD var TH=27; //Top height. 25 might be better In top, adjust these parameters for various fanMount holes. var fanMount=union(mm40FanMount,mm50FanMount); fanMount=mm40FanMount; //if you want both 40 and 50mm FAN mount uncomment I was not having much success on usage of reset button assembly due my printer issue. It was getting broken. So settled for just one more cut/key hole for reset button. In addition, ariflow duct on both sides of base acts as SATA connector cover. You need to use special right angled SATA connector. Cable will go over the top of the board and re-enter from other side to the base, where you can keep your SATA SSD