UFS-118 Polygon Fox Dice Tower

thingiverse

So this remix on Thingiverse is actually from a design on Myminifactory. https://www.myminifactory.com/object/3d-print-blink-fox-dice-tower-108734 The design on Myminifactory credits Jukka Seppänen's Blink Fox. But I don't care about that, because I used a different fox. I just liked the idea of a Fox dice tower, but I wanted a different fox. So I used this low poly fox, https://www.thingiverse.com/thing:937740. I first tried just the fox alone, but the dice rolled too far. I then added a small tray to catch the dice. At 100% scale, at least a 15mm dice will fit. You may want to use supports but keep it to a minimum. I found them hard to remove. Use low infill around 15%. Use coarse resolution to speed up print time. It is a poly fox after all.