Ultimaker GoPro camera Ski Pole mount - Fixed V3

thingiverse

I had chance to have another look at these and revised them a little bit more. Naming convention- mm small fixed- to suit 14mm dia pole, slide on GoPro case mm large fixed- to suit 18mm dia pole, slide on GoPro case the mm * prefix denotes it has been run through meshmixer to add some temp. supports (you may need to re orientate it on the bed, those circular discs are the temp supports and should be on the bottom, ie on the print bed, they break off easily once the print is complete) I stripped some out some lengths and thicknesses, to save on print time and material etc, modified the circular grip / slot to a three point flat grip, (should allow it to be used with a bigger variety of ski pole sizes), made the ziptie holes thinner, added some radius to allow the zipties to grip better, lowered the bolt hole tolerances. Ran the fixed versions through MeshMixer to fix potential overhang issues, which ive had ion the past with the GoPro mounts http://www.youtube.com/watch?v=OJguzFTdoI0