Ultimate CR-6 SE Z stop cover

thingiverse

The ultimate CR-6 SE Z stop cover. Set it and forget it. I couldn't find any good Z stop cover for the Creality CR-6 SE. They all had the wrong dimensions in one way or another—too high, too shallow, too flimsy clips that kept breaking off, not enough space provided for passing through the z stop cable... Worse—they all covered the top of the Z stop bracket. Which is all well and good as long as you keep using the stock glass bed. Until the day when you switch to a magnetic PEI bed, which is a couple of mm lower than the glass bed, and then when you do your first bed levelling, the X axis gantry comes crashing down into the top of the Z stop cover and still tries to keep going, making an awful noise like you think the printer is going to break until you figure out what is going on. Ask me how I know... The top of this cover is flush with the Z stop bracket, so you will never have any problems with the X axis gantry. Even if you're still using the glass bed, do yourself a favour and install this cover, because sooner or later you WILL switch to a magnetic bed, and by then you WILL have forgotten about the cover, and you WILL have the scare of your life. Install this one instead. Set it and forget it. Also made a little notch in the front, so you can still see the pretty red LED. (Though I still haven't figured out what it's good for.) Made for and on the Creality CR-6 SE, which you STILL cannot select in Thingiverse! EDIT: On request, I also made a version for those who use the original spool holder mounted on the front rail.