Ultimate Spinner Button Cap Low Profile Rounded

thingiverse

HI, this is the ultimate spinner cap . There are many, but IMHO all have some problem and i couldn't find one to like . So for 5 min i designed this one. The details: Its rounded so your finger sits there comfortably Separation from bearing, so it clicks in place and is kept straight in its place its diameter is designed so that you see a bit of the bearing for better aesthetics STL is exported properly with high detail so it does not look edgy All, even edge blends are made for beautifull print with standard nozzle Print Settings Printer: Prusa MK2 Rafts: Yes Supports: Yes Resolution: 0.4mm nozzle 0.2mm layer height 0.5mm width Infill: 50 Notes: It is designed specifically for printing to look perfect when you sell it, at normal or ultra quality with 0.4mm nozzle/or 0.2mm/ , layer set at 0.2mm / or 0.1mm/ and layer width set of 0.5mm/0.25/ manual. You could mix the settings, no problem. Just dont print with 0.4mm nozzle at 0.25mm width...just to say it. All edge blends, separation rings , diameters etc. are in line with the above said. so no excuses to look shady Size is exact, so if you printer prints precisely it will be hard to press it there and glue will not be needed. Use small tool vise for that purpose, do not hammer the bearing! Do not print only 2, print 10 at least together, so you dont make a messy blob, especially if you print PETG without fan like me. Same for ABS.