Ultragauge Replacement Mount v2

thingiverse

Tried out the UltraGauge Replacement clip, found it needed a bit more rigidity for my use and my gauge fell out with ease. I took the holes out, increased width of the middle section and added a flat-base mounting option that works well for my Jeep. I printed it in PLA, with the curved bits facing up (if the gauge were installed, the screen would face up) for both designs. I used normal support at 3%. PLA works, but if your car gets hotter than 120F inside, the PLA will deform. PETG is recommended. Holes are 6mm I.D. I didn't design it around any particular screw or bolt but works with some I had on hand. I may post a separate mounting design in the future, depending on application. I also added a flush mount in the rigid design, holes are 6mm I.D. with 8mm recess for screw/bolt heads.