Umarex HDS 68 Rib Riser

prusaprinters

<p>The rib on the HDS is purely decorative as the barrel selector obscures it in use. This rises the rib by an additional ~5mm and adds a small "bead" front sight.</p> <p>It comes in two parts, the barrel shroud/rib and the action shroud/rib.</p> <p>The barrel shroud is attached by:</p> <ul> <li>Removing the screw under the muzzles.</li> <li>Sliding the shroud over the barrels</li> <li>Screwing the muzzle screw back in.</li> </ul> <p>The action shroud is attached by</p> <ul> <li>Removing the two screws holding in the rear rip</li> <li>Clipping the new shroud over</li> <li>Using two new M3 bolds to hold in place.</li> </ul> <p>Use the "Snug Fitting Barrel Band" to check the size before printing the two shrouds.</p> <p><em>THIS IS WORK IN PROGRESS</em></p> <p>NOTE: There is a roughly 4mm gap between the barrel and the action shrouds, as well as other minor issues.</p> <p>NOTE: This is the shroud only, not the stock.</p> <p>Designed in TinkerCad:</p> <p>Snug fitting band: <a href="https://www.tinkercad.com/things/90in5zqflyO">https://www.tinkercad.com/things/90in5zqflyO</a></p> <p>Rib Riser (barrels): <a href="https://www.tinkercad.com/things/dxe9jeNi24v">https://www.tinkercad.com/things/dxe9jeNi24v</a></p> <p>Rib Riser (Body) <a href="https://www.tinkercad.com/things/l2uuNmjSFyd">https://www.tinkercad.com/things/l2uuNmjSFyd</a></p> Category: Sport & Outdoors