Umbrella Release Button Stabilizer

prusaprinters

<p>I included supports in the design, just rip em off in post process. I had to remove some material off the top of the circular section that goes around the umbrella's shaft.</p> <p>Problem: My umbrella's button has a freely rotating release button that has a square piece of plastic attached on the inside part of the handle. When the square piece gets misaligned, the button becomes difficult/impossible to press. This part fixes the rotation of the button and allows consistent umbrella release.</p> <p>If I get around to it, I'll take a picture of it installed on the umbrella. It is currently wet and drying and I do not want to touch it now.</p> <p>This is a very proprietary part, most likely nobody will need this. But I just want to share.</p> <h3> Print Settings</h3> <p><strong>Printer:</strong></p> <p>Print-Rite DIY</p> <p><p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>Yes</p></div><strong>Supports:</strong></p> <p>No</p> <p><p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>whatever</p></div><strong>Infill:</strong></p> <p>50% +, I used 100%</p> </p></p> Category: Replacement Parts