Ummagawd Moongoat- Everything

thingiverse

Moongoat Prints thick and thin arm protectors, print thick with thin wall at 30% infill for a softer bumper. stack guard will just keep the grass out (20x20 only) will remove logos and make the other non ND mount and update soon, feel free to make requests. I recommend running esc reversed or sideways to make life a lot easier, reversed is best for cap placement Shortened SMA connectors for better fit, v2 is 18mm cam cage protector is still in progress, the current design is too visible but it eats goal posts at full stick so until I get a new version going it works, 2 part prints much easier. Mirror for both sides Nose Protector is just cam protector with the visible part removed, wont help in a crash but good for concrete landings capacitor mounts coming soon. I have a dual sma but you would have to run air unit in the center or right angle pigtails, which I don't have to test but I may get to it eventually Added Hero 7 mounts, these are remixed from https://www.thingiverse.com/thing:3455848 The Block part is for the GoPro mounts to enable different support settings in cura (i print 25% infill so the case is soft and 70% for the base because it is taller and needs the support) if you didn't know you can overlap models and use the print per model settings, detailed here: https://3dprinting.stackexchange.com/questions/6522/different-infill-in-the-same-part Please leave requests for parts or changes in the comments