Unicorn Projector LED Lamp Cover (Night light replacement cover)

thingiverse

I created this unicorn themed LED night light cover to replace the typical star or "starry" LED night light covers that are sold under many different brand names. I initially printed in white PLA, but found that the LED brightness was lighting up the room too much, so I did a quick top coat with black spray paint. The outer diameter is 127mm and inner is 124mm, so check your specific light size prior to printing and scale as needed. I was able to print with limited supports, so use your discretion with your print settings and experience as any imperfections will look much larger on the wall since it's projected from the light. I used a support overhang angle of 80 degrees in the settings and it worked out okay. Use your best judgement when defining supports as I'm sure there are better ways to do it. I printed with a small brim since the dome surface area contacting the build plate is minimal. Print time was about 11 hours on an Ender 5 Pro at 0.2mm and 60mm/s.