Universal phone holder with charger hole for desk

thingiverse

I was looking for a nice, compact, universal, wide phone holder that also had a charger hole. I'm not very good at 3D modeling, and there might be a few problems on the model, so it'd be nice if you contributed to it! :D The circle on the bottom of base is supposed to be filled with glue, so it won't slip. I printed it with 0.2mm layer, PLA, raft, no supports. You will probably need WD-40 while placing the other thing. I pushed it to the half, and then sprayed WD40 from corners, then used hammer to push. I will edit it soon, needs smaller width, maybe -0.3mm. If you connect it to charger it stays straight because of charger. The hole needs to be cut with the same angle of these two things that hold the phone. I will try doing that soon. Also, you might add a short USB cable extender, so you don't have to put the cable through hole all the time but to the side, maybe. Good luck!