Updated Fennic Fox for Large Prints

thingiverse

Redesigned this excellent model in Cura , strengthened walls, legs , etc , increased the infil density for the fox himself to100 percent, decrease filler density to 5 percent, increased the gap between the fox himself and the support. One of the biggest problems with this and other models is the legs , when removing support material, you must be really careful or the legs will snap off, they are simply too weak at that point, therefore I increased the walls to 6, and increased the wall thickness to 1.8 , with the support material at 5 percent and better breakaway points this should be easier to take the support off without breaking off any of the legs. Printing is easy, I suggest cleaning the bed with hand soap and a soft cloth (wetted) , then manually level the bed. I have a picture of the fox all done up but there is a part broken, I will put in in this post. Also I have created a special Cura profie for super fine large prints that need support, it too i include as well as the STL.+ If you have an Ender 3 Pro or an Ender 3 V2 then the Gcode file is all ready to go.