USB Cable Extension Clamp together Plate Mounted with Light Bulb Cover and SCD11 mini Switch

thingiverse

Hello This is a USB extension fitting with extra bulb to fit over it. It also has a SCD11 mini switch There are two designs, one what clamps together with M3 nuts and bolts and one whole one. Since the end of the USB extension can be many sizes I made it 14x9.5 (you may need to hot glue it to keep it where it is. The plate is 61x61, Bulb is 50mm and USB tube 30mm You need to make sure no wires are shorting or cut open when stripping. After soldering and exposing the wires (Red connected) Use shrink sleeve where needed, PVC tape and hot glue to keep the cables steady and avoid accidental pulling it off. The bulb I printed without support and the one design is 1mm and these are newer NOT TESTED BULB 1mm and 2mm Some fine sanding and shaping may be required. When I was printing there was allot of bending and moving on the thin bulbs. I changed the design at fit a little to make it better on the bulbs. I will be working on countersunk modules next. This job was a little too much for my mini printer, but it has a a look. Your print could be different. (settings) I hope I loaded the right files. Let me know. Use at own risk Enjoy Tip: You can use spray glue on some alu foil and line the inside of the half bulb to reflect more light.