USB Holder for End Table with Snap-Fit Cover

thingiverse

I wanted a USB holder for the end table by the couch, but most designs I have found allow the cord to slip out of the slots when pulled up for use. I decided to use a snap-fit cover to hold the cords in place. My table only had 16 mm of clearance for the table clamp, so if your table has significantly rounded edges, this might not hold as well as it did for me. A 3D printed M6 plastic bolt holds the camp securely to the table. A few known issues: 1. On my table, the M6 bolt is a bit hard to tighten down because there isn't much clearance. Others with similarly small overhangs will probably have this issue. 2. The USB connectors stick up pretty far. I would like to lower the position of the USB slots a bit so they don't stick up so far above the table top.