uSDX Tri-Band HF Radio Case

thingiverse

This is a case for the uSDX Tri-Band radio. More info on the uSDX Tri-Band radio project can be found here: https://antrak.org.tr/blog/usdx-triband-sdr-all-mode-qrp-transceiver To build this case you will need (in addition to the 3D-printed parts): (2) m3x6mm screws (2) m3x18mm screws (8) m3x8mm screws NOTE1: The uSDX Tri-Band radio consists of a main board and a display board. Before soldering the display board to main board connector you must install the boards into the case and align them. Otherwise the display board may not line-up correctly with the front of the case. NOTE2: There are 2 back plate design files included: back.stl has access holes for only the Mic and speaker jacks back2.stl has additional access for the Speaker-Mic and PTT-out jacks NOTE3: Due to troubles printing the front plate with the pushbutton openings, there is a thin extrusion covering these holes that needs to be cut out after printing. NOTE4: washer.stl is a 1mm thick washer that goes between the Antenna BNC connector and the back plate. NOTE5: spacer.stl is a spacer that fits between the main and RF boards. NOTE6: button.stl is a cap for the pushbuttons. These should be a slip fit but will need to be glued so they stay in place. NOTE7: I printed this in PLA, but you might also consider PETG or ABS filament.