USMILE 210 X Quad frame Parts

thingiverse

These are the parts I made for my USMILE 210 frame. 1 I drop the top plate down to 30 mm standoffs so the camera mounts I had to shrink. I print those in PLA at I think .25 layer height and it typically is perfect height in the frame. I use pliers to smash the end notched nipples to so they are slightly smaller allowing it to fit into the frame slots better. The rear SMA holder I print in TPU and it slides over the rear stand offs, then has thru holes for a zip tie to hold it down, works very well thus far. The GoPro Session Pod is a bit of a remix of someone elses and I downloaded the stl so long ago I cant recall who posted it so I can not give credit at this time. I print this on its side with "Everywhere" selected. Its super jaggedy on one side where the support rests but it doesn't bother me. I use a monoprice mini printer via cura 15.x version. I can share my TPU settings if needed. Hope it helps someone out there instead of starting from scratch. **Edit - 04292018 - Updated the FPV Cam mount as I posted the wrong version that was a tad bit too tall.