uStepper Nema34 Bracket

thingiverse

A Nema34 bracket for the uStepper. The uStepper is originally designed to fit on a Nema17 stepper motor, but has the capability to run some Nema34 motors (but be careful not to overload the driver chip!), so therefore I made a bracket for it! On the back of the Nema34 there should be 4 holes spaced 64 mm apart on each side (center to center) - or approximately 90.5 mm when measured diagonally across the motors center. These four holes should be M4 and with a depth of approximately 1.8mm. There should also be a center hole with a diameter of 17 mm and a depth of approximately 6 mm. Visit www.uStepper.com for more info.