V-Slot Compact Micro SD Card Holder [Creality, Ender]

thingiverse

Hello everyone! This is a simple Micro SD Card Holder that I made using CAD software. What motivated me to make this was that a lot of the available options out there didn't suit my needs, or the tolerances of the SD card slots were a bit too tight for my liking. With my model, you will be able to print multiple ones if needed (each holds 4 Micro SD cards) and stack them on top or next to each other on the V-Slot railing. The nice thing about my model is that I worked out the tolerances on the card slots to fit the more recent commonly used Micro SD Cards that are painted with manufacturer's logos and information. These cards tend to be a bit thicker than the traditional plain/bare Micro SD Cards. As always, you can resize the slots to your liking by making the model skinnier or fatter (tighter or looser) on the slicer software before printing. If the tolerances of the clip are a little tight (prints vary based on people's hardware) then you can use a simple nail file to trim it down little by little until it snaps in to place. When inserting the SD Card Holder to the V-Slot, please insert the back side in and then tilt the model forward where the SD card slots are located. You'll get a satisfying snap/click when it fits properly. Alrighty, I hope you guys like my design, and if you have any questions or suggestions, please feel free to leave a comment. Thanks! -Freddy