V3 Spulholder Anycubic 4Max Pro

thingiverse

V3 of the spulholder for the 4Max Pro. The roll holder is now high enough to accommodate 2kg rolls with a diameter of up to 310mm and a width of 105mm. So that the standard 1kg rolls (up to 78mm wide) also run nicely in the middle of the access to the lid, the roll holder has a recess for them. In general, I have aligned the holder to this center line, before it was slightly offset. For this purpose, as can be seen in the photos, I made a holder for the quick fitting of the bowden tube, since this bowden tube prevents the strong filament from sliding back and to the side. The fitting is intentionally installed diagonally upwards to prevent it from kinking too much, which is also why it is sunk into the material (assembly is better with a pair of pliers) in order to gain the maximum distance. I have taken one or two measures to save some material, but the holder is so big that it can just be printed on the 4Max Pro, I printed it in EasyABS. the filament sensor must be removed to mount the spulholder, since the screw holes are used.