V8R7-II FrSky receiver mount

thingiverse

Receiver mount for the FrSky V8R7-II. In most cases it would be easiest to just attach with double sided tape. However, I have included some mounting clip tabs which are designed to allow it to be attached to Eachine Racer 250. Simply insert the clips AFTER putting the mount in place on the racer 250 and then use a few drops of acetone to weld them in. (assuming you printed them in ABS) The receiver basically just snaps into place (I use that term loosely). No need for zip ties, tape, etc. The easiest thing to use for antenna wire supports is the 3mm coffee stirrer tubes that you can often get for free at convenience stores. The holes in the model are exactly 3mm, but you will probably have to drill them out very slightly to get the tubes to go in. Why did I use the V8R7-II for my receiver rather than an D4R-II ??? Simple... I wanted to wire in transmitter activated LED control, and I also wanted to control the camera tilt in flight with my Taranis. (See http://www.thingiverse.com/thing:1393669) Couldn't do those on my Racer 250 with the D4R-II.