Van's RV-12 ECU Backup Display Mounting Tray

prusaprinters

<p>This pull out-push in tray is for mounting a New Haven LCD display that is used as a backup ECU information display. ECU data is normally displayed on PFD, if the PFD fails the backup ECU display tray can be pulled out to view ECU data. The tray drops 35 degs to provide a better viewing angle when the tray is pulled all the way out.</p><p>There are three files: The New Haven display mounting case, the pull-out tray base, and the mounting base that attaches to the bottom panel tray. Depending on your printer, some minor filing or sanding will be needed as these are close tolerance assemblies and are printed separately. Once the sliding tray base is installed in the mount (slides in from the rear), there are two screw holes that can be tapped for ½" (13mm) #4 screws that will stop the tray from sliding out of the mount. The hole on the right-side face is for a momentary push button switch to change ECU display pages, the hole size is 3/8" and may need to be reamed with a 3/8" drill or step bit. It is designed for a Peerless Electronics press-fit switch. &nbsp; &nbsp;</p>