vape pen clip on

thingiverse

Hi made this guy to hold my vape pens on my belt for easy access. ill modifiy it later to have a better "friction fit" but this should fit most store bought vape pens. Both parts need support but depending on you printer you may need a raft, mine didnt. I sujest 3 outer layers and minimum of 18% support. Infill doesnt matter as long as you have enough floor and roof thickness set. mines always set to 1mm for both. doing this usually means i can print without much if any infill depending on the design of course. This guy was made quickly in tinker just cutting a gun barrel off and shinking a battery belt clip to fit. nothing special but it turned out nice