Vertical Hydroponics System small footprint

grabcad

Vertical Hydroponics System with a small footprint. Standard tubes of 1 inch can be used to connect the modules, which hold the nutrient solution, to each other. The holder has two nozzles in the middle of the 1 inch tube for connecting flexible silicone tubes. And are so out of sight, some eye candy!? These silicone flex tube transport the nutrient solution to the top. Then gravity does the rest. In the branch of the 1 inch tube to the holder are the feed and drain tube with a slope. Also in the 1 inch tube connection is a slope to prevent stagnant nutrient solutions. The drain tube in the branch is larger than the feed tube to avoid overflow in the holder. For the bottom 1 inch tube there is a wrap/bend over the tube walls. To avoid leakage, water cannot creep between the walls of the holder and tube. The same but reversed is done for the top 1 inch tube. The opening is there larger than the internal diameter of the tube. The holder is suitable for the planter (Planter - 3Dponics Snap & Grow Garden ) used in the 3Dponics Snap & Grow System. For shaping the holder express opted for organic curves instead of straight corners. Added a tube holder with a finishing cover. This can hold the 1" tube on the ceiling, floor or both. Or on top of a water container with the nutrients.