Vertical triple sponge holder for kitchen undermount sink

prusaprinters

<p>This sponge holder can hold up to three typical sized dish sponge in a vertical orientation. &nbsp;The sponge holder measures 90mm wide and 130mm deep. &nbsp;Each sponge slot can accommodate 30mm thick sponge.</p><p>It is intended for use with an undermount designed sink. &nbsp;This is so the under side of the sponge holder can sit flat on the countertop with the lip overhanging the edge of the sink for draining water. &nbsp;See attached pictures.</p><p>The rails and dividers are printed separate and needs to be attached by inserting the rail pegs into the holes on the base. &nbsp;No support required on any piece.</p><p>Print 2 dividers and 2 side rails.</p>