VESA 100x100 Rod mount

prusaprinters

<p>I wanted to mount my display vertically, but there wasn't a stand included. I did still have a table leg from a local DIY store with a diameter of 30 mm, so I mounted that to my desk and printed this adapter to mount it.</p><p><strong>Warning</strong>: the display rests on the side, so the adapter itself doesn't carry a lot of weight. Take this into consideration if you decide to mount your display in the air.</p><h3>Printing instructions</h3><p>Printed with PLA at 0.30mm layer height, since it isn't visible and was just a quick print. If you mount the display mid-air, make sure to print it in PETG, because PLA probably isn't durable enough. Infill at 25%. Took 3h10m to print.</p>