VESA Mount Adapter for Dell S2218, S2318, S2319, S2418, S2419, S2718, S2719 Monitors

thingiverse

I bought Some Dell monitors and used them for some time. Eventually I got a mount, so I could have a 4 monitor setup. These didn't have VESA mounts, so I was looking at replacing all my monitors. I decided to model an adapter to fit on my monitor to hold it to my VESA mounts. This is that mount. Print in Nylon, 100% infill, and standing up. No supports needed. you may need to do a little finessing to get it to fit in just right, but it should work well. 9/17/18 Added a Monitor bolt holder. Use a .25" threaded rod and screw into the bolt holder. Use 3m adhesive to stick to the large flat side, and pass the bold through the top largest hole. Use washers and nuts to secure in place at the desired angle. This can also be use for fine angle adjustments. 9/18/18 I awoke to a loud crash. The adhesive pad came loose and flung my monitor towards my desk. It snapped the bracket at the weakest point. So I decided to switch it up. https://www.thingiverse.com/thing:3096003 Use one of these glued to the back of your monitor. Slide a zip tie through and through the top hole of he mount. pull tight and so that it flexes just a little. proper positioning makes the dell logo on the back look like a power symbol, with the zip tie holder splitting the circle vertically. Use super glue or your favorite strong adhesive. Sure, its more permanent, but it's stronger. I printed this out of nylon as well.