VMag/HMag - Nerf Buzz Bee Foam Dart Jungle Mag Adapter

thingiverse

Update 5-23-2019: Added variant HMag. May not address many of the problems in this design, but I expect it to hold up a bit better and be nicer to use. Still only compatible with Buzz Bee 20's. I will be running this variant printed in PETG until I run into issues, and from there I will update the design again if I need to. Quick-swap mag adapters for Buzz Bee 20-dart mags. This project is experimental and has some slight rigidity issues. The spacing between the mags is also not final yet. The initial prototype survived at least half a day of HvZ before I got turned lol. Further testing will happen later. Your printer should be calibrated to reasonably decent tolerances to use this. Design may adapt for Hasbro and other mags with minor changes, not sure. I will not be working on those unless I want to start using 18's. Hardware Required: - 4-40 x 3/8" Countersink Screws - 4-40 Hex Nuts 6 of each for VMag, 4 of each for HMag.