Vocore 5" Dash Enclosure for Fanatec CSL-DD & DDGT-Pro Wheel Base

thingiverse

<b>Vocore 5" Dash Enclosure for Fanatec csl-dd & dd-gtpro wheel bases</b> Hi everybody! This is my first project shared to Thingiverse. Feedback is welcome - I hope this comes in handy for someone who was looking for what I was. The original design was great - main tweaks were for mounting & narrowing the complete build down. The case design itself was already great and I take no credit for it. :) <b>Righto boys & girls here's what I did:</b> Printed the 4 stl files on my FLSUN Super Racer - 0.2mm layers, 100% infill, 100mm/sec. No supports needed. Pictured print is using eSun PLA+ at 210/60 <b>Parts:</b> * M3 x 16mm Bolt (x4) * M6 x 16mm Bolt (x2) * 10mm x 3mm Magnet (x4) * Vocore screen 5" (x1) * Hot glue gun * cable tie (x1) * 2m braided Micro USB cable <b>What I have remixed:</b> <b>Base Plate:</b> * Changed screw holes to 3mm * Added in magnet mounts to suit 10mm x 3mm magnets * Added notch to bottom right for USB cable * Dropped the overall height down from (I think) 17mm to 10mm - quicker to print, neater package, and plenty of room for the USB cable I used. <b>Centre Plate: </b> Unchanged <b>Top Plate: </b> Unchanged <b>CSL-DD/DD-GTPro Bracket:</b> Designed simple adjustable magnet bracket to suit CSL DD / DD-GT Pro wheel base. I believe the spacing also suits other Fanatec wheel bases but I am unable to test. ~~I should have made the arms for the screw holes wider to match the cross bar - it would have been neater & stronger. I may update this but this won't affect usage in any way.~~ Used a small dab of glue to hold magnets in bracket. <b>UPDATE 26/07:</b> Added V2 of the bracket. * Removed the holes and went for a slot layout instead - finer adjustment & goes lower overall than before. * Bracket significantly stronger - widened to match T-bar. Looks better too * Added a pretty little border for a filament change print. See pics of new bracket above. Don't use the original bracket at all, no reason to. <b>Other Notes:</b> Had issue with the base warping with pictured print, however warping was minimal and actually suited the design of the case so I am moving it from the 'mistake' column to the 'undocumented feature' column. Used a small cable tie to hold USB cable in place - any pressure on cable will be stopped by USB plug & cable tie and will not damage ribbon connectors on the screen <b>Simhub Setup:</b> 1) Install Windows Driver: Link to current USB drivers for Windows 10/11: https://simhubdash.com/Drivers/VOCOREScreenSetup.exe (I have tested in Windows 11 and it works fine) 2) In Simhub under Dash Studio / VOCORE and 'enable display' 3) adjust settings to taste and you're done! That's really it! Special thanks in general go to <b>Michael Laws @ TeachingTech</b> - if it wasn't for your videos so many of us would never have gotten anywhere. https://www.youtube.com/c/TeachingTech