Volvo "R Design" Badge Holder - Front Grille - C30/V40/C70/XC90 - 2004+

thingiverse

Slips straight into the Grill of 04+ Volvo and stays in place with clips at the back. (In the photo with it on my Vovlo, I've realised the actual R-Design position is the next slot along, close to the headlight - The bracket will also fit in that position as well.) Print Settings Printer: G2S Pro Rafts: No Supports: Yes Resolution: 0.2 Infill: 20% Notes: When you print it, put the clip face down, so the posts are pointing upwards. You will need some supports under the face to stop it drooping. I used 15% support with 0.8X offest and 0.8Z offset in Cura This gave me a nice "ribbon" to pull when finished and all the support material came straight out. The posts are self supporting. Just clean them up when printed (some ooze etc)