Voron Switchwire Deck Panels

prusaprinters

<p>This is a simple printable 2 part deck panel for the Voron Switchwire. I've added 3 additional mounting holes to better align the panels, and more rigidly mount them. The panel is split in 2 parts that just fit on the VSW build plate.</p><p>I'm including a little bracket to mount on the Y axis extrusion that gives a couple of zip tie points and can be mounted on the control board and raspberry pi side to provide some extra support where the front and rear plates meet on the right side of the printer. The PSU provides all the support you need on the left side.</p><p>Print in ABS with brim.</p><p>If they warp a little, heat your bed to ~80, place it on the bed, and lay a hard cover book on top of it after it's warmed up. Turn off the bed, and allow it to cool down all the way. That should take care of any warping.</p><p>NOTE: for printing, this is provided as 2 files, you will need to print those once as they are, and mirror them in the slicer to print them again, for a total of 4 prints.</p>