Voron V0/.01 Z endstop

thingiverse

**Documentation is still work in progress** I always wanted to have Automatic Z offset on my Voron V0. So I modded Unklicky endstop sexbolt (https://github.com/majarspeed/Unklicky/tree/main/Unklicky_Endstops/Unklicky_SexBolt) a bit to make to the load lighter, adjusting the mounting hole, make a screw block and attached it on the bed extrusion. I am currently using Unklicky probe　（https://github.com/jlas1/Klicky-Probe/tree/main/Probes/Unklicky). Klicky probe should also work. I stacked 10mm M3 countersunk screw and M5 washer and use it as pin head. you can stacked some m3 washer to held it firmly and for adjusting the pin height. I added 3 screw block sizes, the pin should overlap with the bed a least 1mm (Please see photo). I use 22mm the nozzle is almost touching the edge of the washer. NOTE: **You need to re-route Endstop wire through Z wire cable chain** **You will lose some print area** What you need: For Pin head: 1pc 10mm m3 countersunk screw 1pc M5 washer Few M3 washers (Optional) For Screw block: 15mm M3 SHSC/BCSC 2pcs M3 heat set (4x5x3) Unklicky probe: 1pc 20mm M3 screw 2pc M3 heat set (4x5x3) 2pcs 3x6 round magnet 24AWG Wires M3 washer (Optional) Please use Voron recommended print settings. ABS/ABS+ Please see photo for print orientation.