Vortex 150 - Runcam Split mini mount

thingiverse

This thing allows you to mount a runcam split to your ImmersionRC Vortex 150. It includes a mount for the actual camera module aswell as for the PCB Stack. Please note that all steps of the installation procedure need to be performed in a partucular order for it to go together correctly. ###Instructions: >1) Remove 4 screws that hold the front skidplate and remove it and the piece of plastic it is holding. You won't need those parts (with the exception of the screws) for this installation. >2) Remove 2 screws that hold the plastic camera dome. Unplug the camera from the main PCB and take it out of the dome. > >3) Assamble the runcam PCB stack with the included M2 spacers and nuts, you probably can't fit the front top nuts because of the screwheads that hold the camera dome, so just leave those to nuts off. > >4) Cut the cable that came with the origignal camera and solder one end to the runcams GND, 5V and Video Pads, you probably need to extend the wires. in order to reach the connector on the vortex PCB. > >5) Plug the FPV signal connector into the main PCB of the vortex, make sure to connect it to the actual video connector, and not the other one next to it. You can use a rubber band to keep the PCB in place while you work on the camera module. > >6) Insert the Runcam Camera Moduie into the camera adapter clip and secure it with 2 M2 screws > >7) Insert the Camera module with adapter clip into the camera dome and secure everything with 2 M3 Screws in the bottom and 2 M2 screws in the top. The holes for the M3 screws should be tapped before. > >8) Push the Runcam Flex Cable through the Hole in the top Carbon plate the dome sits on and connect it to the PCB. Now Srew the dome back into place. > >9) Use the 4 M3 screws you took out in step 1 to secure the new PCB Moint to the bottom of the Vortex > >10) Use 4 M2 screws included with the Runcam to secure the PCB Stack to the mount.