Voxelab Aquila Magnetic Fan Shroud

prusaprinters

<p>Based on the CR10 Magnetic Fan Shroud by <a href="https://www.thingiverse.com/thing:5163184">ericthepear on Thingiverse</a>. Makes for much easier access of the fans, hot end and nozzle compared to the stock fan shroud which is a pain to take off.</p><p>This version fits the Voxelab Aquila and makes use of 10mm x 3mm neodymium magnets. It uses embedded magnets because I was tired of having to wait for the glue to dry if I didn't embed them in the print (use a ‘pause at height’ function in your slicer, mine was in Cura).</p><p>Have the print pause after the layer BEFORE the magnet holes are covered. I do recommend putting a SMALL dab of the super glue or epoxy of your choice in each hole before carefully putting the magnets in.</p><p>V2: Uses only two magnets at the top, has an extra peg to help the lining up of the shroud with the carriage mount. Has hex nut cutouts for the hotend cooling fan (not all screws need to be secured). Part cooling fan holes should still be small enough to hold an M2 screw tightly.</p><p>V1: Not recommended for making other prints with embedded magnets, as the magnets in the bottom of the shroud can pull up the magnets from your print.</p><p>WARNING: the fan mounts don't take screws easily (I can't get the right width right now), but the fans should be able to sit in place fine without screws.</p>