Voxelab Aquila X2 Fan Duct & Rail Brace

thingiverse

This is a fan duct design based off both the Satsana 5015 Remix, along with my Longer LK5 Pro Fan Duct design. It's very, very similar with the LK5 Pro design, but the mounting is different. I'm not a fan of the sparse mounting options for anything other than the stock design, so I had to incorporate the rail brace, just as in the LK5 design. It had that same dang slight droop on the right hand side, so I added back in the rail brace portion. I was hoping to make it just an all-in-one design, but alas, it wasn't possible. I used a M3 knurled brass insert (M3x4.6x5.7mm from Amazon) set into the main duct, that allows the retention bracket piece to screw into to add that support. All fan mounting screws are M3. The 40mm from fan location will work with either a 40x40x10, or a 40x40x20 fan. A standard 5015 blower fan on the right side will work just fine with M3x20 screws. All screw holes are self tapping, apart from the hole with the insert.