Wahl Designer Clipper Guard, 1.5"

thingiverse

I made some adjustments to rmeyers's 1.5" custom guard: Scaled the model to millimeters. Reoriented the model so it sits the way I print it (see below). Changed where the tabs and sides are so it fits my clippers (Wahl Designer). Thickened and reinforced several areas of the model. Rounded the tips so they're not so sharp and stabby. When I printed the original (after changing the attachment area so it fit my clippers), it broke. The way I have the model oriented here, it ends up needing supports to print, but it's printed in a way that it's less likely to snap from the stresses put on it by the clippers. And I adjusted the model to reinforce several of the weaker areas. I've used these to trim my hair. They work about as well as the guards that came with the clippers (though they do make a lot more noise, due to vibrations). Print Settings Printer: Wanhao Duplicator I3 Rafts: No Supports: Yes Resolution: 0.2mm Infill: 25% Notes: Printed in PLA. Sliced using Cura. Platform adhesion type: Brim. Support type: Everywhere. Shell thickness: 0.8mm Bottom/Top thickness: 1mm