Wall Holder for Hewlett Packard ZBook 15 Mobile Workstation

thingiverse

I wanted my work notebook off my desk for space and noise reasons, so I designed this wall holder. Hole spacing is 60 mm, a 4 mm Philips flat head wood screw will fit. I designed this for a pretty hefty 15 inch mobile workstation, so most any notebook should fit. You need to adjust the spacing of the two pieces to your requirements of course. I printed this in PETG 0.2 mm resolution. The slight angle away from the wall is intentional so that the hot air exhausted out the bottom of the notebook can escape better, also easier to drop it into the slot.