Wall Hook and Rail System

thingiverse

System includes hooks which may be mounted on the wall by use of a rail system similar to a DIN rail system. The rail is 1 inch tall and several lengths are included from 6 to 10 inches. All size hooks will fit any length rail and can be slid on and off after mounting the rail. Rails are designed with recesses to allow standard dry wall screws to mount flush and allow hooks to slide past. Update: added a 1/2 inch dowel rod clip and a extended medium hook. PLA rails and hooks can support several pounds safely (test it first, don't hang anything of significant weight which you can't afford to have fall or anything which may cause injury or damage to anyone or anything below it). Other printed materials or higher percentages of infill may result in higher capacities. Keep loads positioned in the middle of the hooks or in the hanger holes (included on the larger hooks). Do not load the tip of the hooks with significant weight as that will pry against the din rail and may result in system failure. The greatest weight can be hung in the hanger holes in the large hooks due to those hole's proximity to the wall resulting in less bending stresses. The medium size hook likely has the largest hook capacity due to the its shorter extension from the wall resulting in less prying force on the rail. Position hooks carrying the most weight very near or directly over the screw locations for best results. Screw anchors are recommended when installing into drywall. By downloading and printing these files you agree to take sole responsibility for harm or damages which may result in using (and/or misusing) this system. And you do not hold me responsible for any harm or damage which may occur from any failure of this system.