Wall Outlet Safety Cover With Break away ends

thingiverse

(PRINT STANDING UPRIGHT) This allows the hinge to print correctly. This is a Wall Outlet Safety Cover with break away ends. It attaches just like a normal outlet cover with the screw in the center. DO NOT OVER TIGHTEN you may break it. I made this because my daughter keep pulling the plug out of the wall. They are only .25mm thick so they will come out depending on what direction you want the door to open and if you need the cord to come out the top or bottom. I did need to trim the corner off mine after printing because I did not think about the cord was coming off the plug at an angle. I did make this a bit deeper so you may not need to do this if you have the same kind of cord. Also made the front opening a bit wider to better fit the plug in. Please see photos.