Wallmount for Vorwerk Kobold vacuum cleaner attachment set

cults3d

A wallmount for the Vorwerk Kobold vacuum cleaner attachment set. Unfortunately looks like Vorwerk sells well thought out Devices but doesn't waste one thought on how the accessories could be stored properly. I only used some few supports in the middle of the rectangle box, but would probably also work without. Unfortunately, I had some warping issues with this material. I used 20% infill. But 10% should be enough I think. Either two or three M3x15mm screws with nuts are required to connect the two parts. Then the wallmount can be attached to the wall with two additional screws. The two parts can also be used seperately, but then the attachment on the front side has no "snap in" because this is on the upper half. The two "Nippels" on the lower half are 1mm longer because the extension tube as seen attached below appears to be a bit wider. The wallmount is designed for the items delivered in VT300 "Komfort-Set". Others may fit also, but were not tested.