Wally_Customizer + Neutrik

thingiverse

I added in the plate collection a Neutrik port. It has 2 holes as standard. The SCAD files has all 4 mounting holes there. Just remove the "//" on lines 598,599, 610,611, 621,622. The ports couldn't be centered as a outlet is, since they would overlap. They are set off center 3.75mm, so 7.5mm between them when using 2. A third was added to be centered if either top or bottom are selected as Neutrik and the other as none. For a single top or bottom Port, set the other as Blank. I'm new to SCAD, so this may have been able to do with less lines by using variables. I'll try that later.