Wanhao Duplicator i3 Plus Enclosure Kit feet

thingiverse

I wanted an enclosure for the Wanhao Duplicator i3 Plus since I had problems with layer adhesion when printing ABS on it. I found the Duplicator i3 Enclosure Kit, but it didn´t quite fit the i3 Plus so I made some really simple feet to raise the enclosure up 30mm. I got much better results with the enclosure even though it´s got a 30mm gap to the table. I have not tried if it makes any difference closing the gap to the table. I also made a version of feet that are 75mm high for raising the front up as high as possible but I have not printed or tested these yet. The 75mm feet might be required to make sure the filament isn't bent if you print really high prints, I haven't tried that though. Using the 75mm feet will probably require closing the gap between the front part of the enclosure and the table. Print Settings Printer: Wanhao Duplicator i3 Plus Rafts: No Resolution: 0,2mm Infill: 50% Notes: I´m using 8 feet in total.